AI-generated imageGuides · Food and nutrition · Updated 2026-11-01
How do you read a nutrition label?
Start with the serving size and servings per container, because every number below them is for one serving. Then check the calories and protein. Use the % Daily Value to judge the rest: FDA treats 5% or less per serving as low and 20% or more as high. Most people should keep added sugars and sodium low.
- Check the serving size. Find the serving size and servings per container at the top. Every number on the label is for one serving, so note how much of the package you will really eat.
- Read the calories. Calories are the large number. Multiply by the number of servings you eat. Eat two servings and you get twice the calories.
- Scan the % Daily Value. Look down the right side. 5% DV or less per serving is low, and 20% DV or more is high. Remember the percentages are also for one serving.
- Look at added sugars. Added sugars sit under total sugars. Aim low here. The Daily Value is 50 grams for the whole day.
- Find the protein. Protein is near the bottom, in grams. Most labels don't show a % DV for it, so compare the grams with your own daily target.
Start with the serving size
The top of the label tells you two things: the serving size and how many servings are in the package. Everything below is for one serving. If you eat two servings, every number doubles, including the calories and the % Daily Values.
The serving size isn’t advice. FDA says plainly that the serving sizes on labels “are not recommended serving sizes.” By law they’re based on how much people actually eat. That’s why the updated label raised some of them. A serving of ice cream went from half a cup to two-thirds of a cup, and the reference amount for yogurt is now 6 ounces.
Some packages make this easier:
- One-serving packages. A 20-ounce soda or a 15-ounce can of soup can now be labeled as a single serving, since most people finish it in one go.
- Two-column labels. Packages that hold two to three servings, such as a 19-ounce can of soup or a 3-ounce bag of chips, show the numbers per serving and for the whole package side by side.
Packages with more than three servings, like a party-size bag of chips, only show one serving.
Read the calories
Calories are the biggest number on the label. They tell you how much energy one serving gives you. FDA uses 2,000 calories a day as a general guide, but your own number depends on your age, sex, height, weight and how active you are. Our TDEE calculator gives you a starting point, and our guide to how many calories to eat to lose weight covers the next step.
Use the % Daily Value
The % Daily Value (% DV) on the right side shows how much of a day’s worth of each nutrient one serving gives you, based on 2,000 calories. You don’t have to do any math with it. FDA’s rule of thumb:
| % DV per serving | What it means |
|---|---|
| 5% or less | Low |
| 20% or more | High |
Use it to compare two foods, or to see whether a food is a big or small source of something.
Aim low on saturated fat and sodium. Aim low on added sugars too. For these, a food at 20% DV or more is a lot.
Aim high on fiber, vitamin D, calcium, iron and potassium. FDA lists these as nutrients to get more of, so 20% DV or more is a good sign.
Trans fat is listed in grams with no % DV, because experts couldn’t set a daily amount for it. Lower is better.
Added sugars vs total sugars
The label shows two sugar lines:
- Total sugars is all the sugar in a serving, including the natural sugar in milk and fruit. It has no % DV.
- Added sugars is sugar put in while the food was made, such as syrups or honey.
The Daily Value for added sugars is 50 grams. That matches the advice to keep added sugars under 10 percent of your calories, which is about 200 calories on a 2,000 calorie diet. Two foods can have the same total sugars, and the added sugars line shows you which one had sugar mixed in.
Find the protein
Protein is listed in grams. Most labels don’t show a % DV for it, because FDA only requires one when the package makes a protein claim or the food is for young children. The Daily Value is 50 grams. That’s a general figure, and your own target may differ.
So compare the grams to your own target. Our protein calculator works one out, and our high-protein breakfast guide has ideas for getting there.
Using the label to log food
A label is the easiest food to log, because the numbers are already there. Two steps get it right:
- Work out how many servings you ate. If the label says a serving is 30 grams and you ate 45, that’s one and a half servings. A kitchen scale helps, but you can also count pieces or use the package. Our guide to counting calories without a food scale has more tricks.
- Multiply. Log the calories, protein, carbs and fat for the servings you ate, not for one serving.
Two things to know about label numbers:
- They’re rounded. Calories are shown to the nearest 10 above 50 calories, and anything under 5 calories can be shown as zero. Fat under half a gram can be shown as zero too. If you use a lot of something listed as zero, it can add up.
- They allow some room. Under FDA rules, a food is mislabeled if it has more than 20 percent more calories, sugar, fat or sodium than the label says. So a food can run a little over its label and still be within the rules.
That’s close enough for most goals. If you log the same way every day and watch your weekly weight trend, you can adjust when the trend doesn’t match your goal. For food that has no label, see calories in homemade food, and for the bigger picture, our guide to how to track macros.
You can also skip the math. Take a photo of the label or read it out to an AI assistant, then say how much you ate. It works out the numbers for you.
Also asked
What should you look at first on a nutrition label?
The serving size and servings per container. Every other number is for one serving, so if you eat the whole package and it holds two servings, double everything.
What does % Daily Value mean?
It's how much of a day's worth of a nutrient one serving gives you, based on a 2,000 calorie diet. FDA's rule of thumb is that 5% or less is low and 20% or more is high.
Is 20% Daily Value a lot?
Yes. FDA calls 20% DV or more per serving high. That's good for fiber, vitamin D, calcium or potassium. For sodium or added sugars, it's a sign to eat less of that food or eat it less often.
Why doesn't protein have a % Daily Value?
FDA only requires a % DV for protein when the package makes a protein claim, or when the food is for children under 4. The Daily Value for protein is 50 grams, a general figure. Your own target may differ, so compare the grams with it.
What's the difference between total sugars and added sugars?
Total sugars counts all the sugar in a serving, including the natural sugar in milk and fruit. Added sugars counts only the sugar put in during processing, such as syrups or honey. Added sugars is the line to keep low.
Is the serving size how much you should eat?
No. By law it's based on how much people usually eat, not how much they should. Eat the amount that fits your goals, and adjust the numbers to match.
Sources
- U.S. Food and Drug Administration, How to Understand and Use the Nutrition Facts Label
- U.S. Food and Drug Administration, Added Sugars on the Nutrition Facts Label
- U.S. Food and Drug Administration, Daily Value on the Nutrition and Supplement Facts Labels
- U.S. Food and Drug Administration, Food Serving Sizes Have a Reality Check
- 21 CFR 101.9, Nutrition labeling of food (rounding and compliance rules), via Cornell Legal Information Institute
- MedlinePlus (National Library of Medicine), How to read food labels